ETC ION Operation Manual page 351

then press down gently on the right wing until it is fully seated. This should be a
smooth connection but may require a little force.
Step 6: Repeat above procedure to connect another wing to the right end of the pair, if
desired.
Step 7: Re-insert screws to secure wings together and secure the bumpers to the sides of the
wings.
A t t a c h f a d e r w i n g a r r a y t o I o n
Once all of the desired wings are attached (within the limits above), you may use the same
procedure above to attach the wings to Ion.
C o n n e c t U n i v e r s a l F a d e r W i n g ( s ) t o C o n s o l e w i t h U S B C a b l e
Connect PS313-F
Step 1: With the console power off, connect the USB cable (provided) between the console
and one wing as shown above. If multiple wings are joined, only one power and one
USB connection is required for all joined wings.
Step 2: Using the power supply adaptor kit, connect the fader wing to a power source.
Step 3: It is recommended that you run the power and USB cables through the strain relief
included on the back of the wings.
Step 4: Turn the console on.
F
Universal Fader Wings
power supply
cable
(included)
Connect
USB cable
(included)
Connect to USB
on the console
337