ETC ION Operation Manual page 281

While in the macro editor display, the following functions may be performed using the control
keypad and softkeys:
• [Label] - when a macro is selected and [Label] is pressed, the alphanumeric keypad will
display on the CIA. Label the macro and press [Enter].
• [1] [Label] <name> [Enter] - labels macro 1
• [Delete] - when a macro is selected and [Delete] [Enter] is pressed, you will be prompted to
confirm the deletion of the selected macro. To confirm press [Enter], to abort press [Clear].
• [1] [Delete] [Enter] [Enter] - deletes macro 1 from the list.
• [Copy To] - when a macro is selected and [Copy To] is pressed, you will be prompted to enter
the macro number that you want to copy the contents of the selected macro to. You will be
prompted to confirm the copy process, press [Enter] to confirm or [Clear] to abort the copy
to process.
• [1] [Copy To] [6] [Enter] [Enter] - copies the entire contents of macro 1 to macro 6.
• {Edit} - when a macro is selected and {Edit} is pressed, you will have entered edit mode for
the selected macro. Three notable changes to your macro editor display include:
• A blinking cursor in the macro content detail portion (top) of the display.
• "Press [Select] to save or [Escape] to cancel changes" flashes above the command
line.
• The available softkeys change to {Loop Begin}, {Loop Num}, {Wait}, {Delete},
{Cancel}, and {Done}.
• {Move To} - allows you to move and reorganize your macros anywhere in the macro list
numerically.
• For instance, if you have macros 1 through 5 in the list, and you want to move or change
macro 1 to macro 6 so that your most commonly used macros are first in the list, you
would press [1] {Move To} [6] [Enter]. This leaves only macros 2 through 6 in the list.
22
Storing and Using Macros 267