ETC ION Operation Manual page 131

S h u t t e r C o n t r o l
Pressing the [Shutter] button displays shutter controls, if there are any fixtures with framing
devices patched.
Press the [Shutter] button again to access the additional shutter controls, available to the specific
channel.
Color Contr o l
Depending upon the specific device, color can be established manually with the encoders using:
• CMY color-mixing
• Hue and saturation color mixing
• RGB color-mixing
• Selection from a color wheel or scroller
You may also specify color by using the hue and saturation (HS) color picker and gel picker.
It is also possible to set non-intensity parameter data with direct entry using the control keypad and
using the parameters on the CIA.
• [1] [At] [4] <0> {Cyan} [5] [5] [Enter]
N o t e :
C u s t o m C o n t r o l
Pressing the [Custom] button displays intensity controls.
8
Basic Manual Control
Color scroller data will display on the encoders and displays as frame numbers,
F1, which would be frame 1, F2 for frame 2, etc. F1.5 is halfway between 1 and 2.
F2+ will display if the frame is less than 2.5 and F2- if the frame is greater than 1.5.
After the frame number, the gel number will also be displayed.
Frame numbers can be used from the command line. [2]{Scroller}[5][Enter] will
send channel 2's scroller to frame 5. Frames can also be selected by using the
DMX address for that frame. Pressing [/] twice will post DMX to the command line.
[3] {Scroller} [/][/][2][5][5] [Enter] will send channel 3's scroller to the frame with
the DMX address of 255.
117