Using Stop Effect; Release A Fader; Turning A Fader Off - ETC ION Operation Manual

U s i n g S t o p E f f e c t
The {Stop Effect} softkey can be used to stop all effects from operating on any or all faders, or it
may be used with the control keypad to stop a specific effect.
• To stop all effects on a fader, press [Fader Controls] {Stop Effect} & [Load] of the
associated fader.
• To stop a specific effect regardless of the fader it is operating on, press [Effect] [2] [Fader
Controls] {Stop Effect} [Enter].
When an effect is stopped, all impact of the effect is removed and the stage output is as though the
effect has never been activated.
R e l e a s e a F a d e r
To release a fader, thereby clearing all cues from that fader, press [Fader Controls] {Release} &
[Load] for the associated fader. When a fader is unloaded, control is returned to the master fader.
If there are no values for unloaded channels from the master fader, channels are set to default.
Channels return to the master fader using the category level timing of the active cue on that fader.
If the master fader is released, the fader is cleared and any intensity values owned by that fader are
set to zero, any non-intensity parameters remain in their current state.
All fader attributes (timing disable, filters, and so on) are cleared by the release action.
T u r n i ng a F a d e r O f f
To turn a fader off, press [Fader Controls] {Off} & [Load] of the associated fader. When a fader is
turned off, the cue list is maintained on that fader, and any values provided by the fader are returned
to the master fader or their background state.
Press {Off} & [Load] again to turn the associated fader back on. The active cue is replayed,
following the rules for assert.
You can turn the fader back on by pressing the Go or Stop/Back button on the fader, or by executing
a [Go to Cue] for the cue list on that fader, provided the cue list is not already active on another
playback.
17
Cue Playback 219