Playback Fader Controls; Go And Stop/Back; [Go To Cue] [0] - ETC ION Operation Manual

Playback Fader Controls

In Ion, many of the buttons mentioned below exist as softkeys. In order to have access to some of
these keys, press [Fader Control]. The softkeys will change to display the fader control keys. You
may press [More SK] if the green LED is illuminated, to view additional fader control buttons.
G o a n d S t o p / B a c k
Using [Go]
The [Go] button is used to execute the cue currently in the pending file of the associated fader.
When [Go] is pressed, all parameters assume their required positions in the recorded times, unless
they have been recorded with manual timing.
U s i n g [ S t o p / B a c k ]
All fader activity can be instantly stopped mid-transition by pressing the [Stop/Back] button for the
required fader. To resume the cue, press the [Go] button. To fade to the previous cue on that fader,
using default "back" timing, press the [Stop/Back] button again from this state.
When a cue on the playback fader is complete, the first press of [Stop/Back] will go back to the
previous cue. Subsequent presses of [Stop/Back] will step backwards sequentially through the
cue list from that point. [Stop/Back] uses default back time as established in Setup.
Settings" on page 95.
• [Go to Cue] [Last] [Time] [n] [Enter].
[G o T o C u e ] [ 0 ]
You can use the [Go To Cue] [0] button, located with the playback controls, in conjunction with a
fader load button, to send a specific cue list to cue 0. This action does not use the command line.
To do this:
Step 1:
Step 2:
Step 3:
Step 4:
For more information on this action, see
17
Cue Playback
Or you can back into the previous cue using specific timing by pressing:
Press [Fader Controls]
If necessary, press [More SK] until {Go ToQ 0} is visible in the LCD.
Press and release {Go To Cue 0}.
Press or click [Load] for the desired fader. The cue list will go to cue 0.
Using Go To Cue 0, page
See "Cue
191.
215