Network Settings - ETC ION Operation Manual

Network Settings

Ion Console IP Settings
This is where you specify the IP
address to be used by this
console (manually) or how it
acquires an IP address
(dynamically via a DHCP
server or a link-local address).
Net3 Services Settings
These are settings for the
network services that may be
running on your Ion console.
If you are unable to enable
them, they are not currently
installed on this console.
N e t w o r k A d a p te r
This reports if the network adapter is "Online" (configured, connected to a network and operational).
It reports as "Offline" if any one of the above conditions is not true.
P r o to c o l s
This is for selecting which protocols the console will output and which ones are included in the
default.
AC N Priority
This sets the control priority for ACN data from this console. The valid range for this setting is 1
(lowest) to 200 (highest). This is the reverse of ETCNet2.
E T C N e t 2 P r i o r i t y
This sets the control priority for ETCNet2 data from this console. The valid range for this setting is
20 (lowest) to 1 (highest). This is the reverse of ACN.
Local DMX
This enables DMX output from the local ports on an Ion console.
A v a b U D P
This sets the subnet for Avab UDP data from this console. The valid range for this setting is 0-9.
ArtN et
This sets the subnet for ArtNet data from this console. The valid range for this setting is 0-15.
E n a b l e O u t p u t i n O f f l i n e M o d e
Checking this box allows for output in offline mode for use with a visualization program.
A
Eos Configuration Utility (Eos Shell) 299