Hardware Setup - ETC ION Operation Manual

Hardware Setup

R e a r P a n e l
Hard Power
Switch
AC Power
IEC connector
Step 1: Attach the appropriate IEC power cord to the power connector, then to an AC
receptacle.
Step 2: Attach the dual DVI connector/Y-adapter to the DVI port.
N o t e :
Step 3: Connect the USB mouse and keyboard to the USB connectors. If you wish to use a
PS2 mouse or keyboard (not provided), use the appropriate connectors on the RVI.
Step 4: Attach a network ethernet cable to the Ethernet port. All communications to the
associated control console are made over this Ethernet connection.
Step 5: When all connections are made, activate the hard power switch on the rear panel.
Step 6: Press the soft power switch, on the front of the unit, to power up the RVI.
N o t e :
320
Dual DVI
Display
AC Input
100-240 VAC
50/60 Hz 2A
Electronic Theatre Controls, Inc.
Middleton, WI Made in USA
If you have VGA monitors, attach the VGA adapters (provided) to the DVI Y-
adapter. Do not use the VGA connectors on the back of the RVI.
The minimum screen resolution must be at least 1280x1024 with 32 bit color.
• Connection to the console may be made either directly using a Cat5 or better
null-modem cable or through an Ethernet hub or Ethernet switch using standard
Cat5 or better patch cables.
If the unit does not power up, check the hard power switch on the rear panel, to
ensure it is switched on.
Not Used
Net3 RVI
1
2
RS-232
Mouse
Keyboard
Ethernet
BTX - L OP IOSHLDR
USB
x4
Not Used
Ion Operations Manual