Using [Recall From] - ETC ION Operation Manual

Using [Recall From]

[Recall From] is similar to [Copy To], except that it retrieves data from other locations, and can be
used only for a channel list recalling from the same channel list but in a different location (for
example, a cue). [Recall From] is essentially a "copy from" command.
All parameter data for selected channels will be recalled, or by using the IFCB category buttons or
parameter buttons, you may recall subsets of channel data. To only recall only intensity levels, use
the {Only Levels} softkey.
Below are some examples of recall commands from record targets:
• [2] [Recall From] <Cue> [5] [Enter] - recalls all recorded data from cue 5 for channel 2.
• [2] [-] [Focus] [Recall From] <Cue> [5] [Enter] - recalls all data for channel 2 from cue 5,
except focus (pan/tilt - XYZ) data.
• [Group] [3] [Color] [Focus] [Recall From] [Preset] [6] [Enter] - recalls the color and focus
information from preset 6 for the channels in group 3. Could also be used with a channel
selection set instead of a group.
• [Group] [3] [Color] [Recall From] <Cue> [7] [Make Absolute] [Enter] - recalls color data for
group 3 from cue 7 and breaks any references to record targets.
• [2] [Recall From] [Sub] [4] [Enter] - recalls all recorded intensity data from sub 4 for channel
2.
• [Recall From] [Intensity Palette] [1]- recalls all of the values stored in intensity palette 1.
.
N o t e :
15
Advanced Manual Control
In live or blind, hitting [Recall From][Recall From] will put [Recall From][Cue]
on the command line.
197