Start Up - ETC ION Operation Manual

F r o n t P a n e l
Removable
label strip
Live
Blind
B a c k li t L E D s
LEDs indicate which mode the unit is operating in (client or offline) and the status of the operation
(sync).
• The "Client" LED will illuminate when the unit is connected as a client of the master
processor.
• Additionally the "Sync" LED will illuminate when the data has been synchronized to the
master console.
• The "Offline" LED will illuminate when the unit is running offline and is no longer in
"Client" mode.
C o m m a n d K e y p a d B u t t o n s
The 20 buttons are configurable from the Eos Configuration Utility (ECU). They are set to a default
configuration. The label strips for these buttons are removable and reversible. Any changes to the
button configuration can be written on the opposite side in pencil.
US B Port
The USB port on the front of the RVI unit may be used to connect a USB storage device for show
downloading, uploading, or software updates.

Start Up

At initial startup, the RVI will display the Eos and the Congo logos. Use the mouse to select the Eos
operating system. The RVI will initialize to the Eos environment each time the power is cycled,
unless you choose to revert the operating system in the related settings menu (see "Switch to
Congo from Eos Operating Mode," in the Net3 Remote Video Interface Setup Guide, page 4).
C A U T I O N :
D
Remote Video Interface (RVI)
20 command keypad
buttons
Tab Escape Select M001
M005
Scroll Lock
If you "Exit Eos" and enter the ECU, do not select the "Master" or "Backup" buttons
that are displayed in the ECU welcome screen.
The Net3 RVI will only function as a "Client" on the Eos network or "Offline".
Backlit indicators
M002 M003 M004
Stop/Back
M006 M007 M008 GO
USB
Primary Backup
Master Sync Offline
Soft power
switch
321