Table of Contents
Advertisement
Recommended ETC Dimmer Settings
See the ETC website for the recommended settings for ETC dimmers when
used with the Navis 100 Sidekick LED driver:
Sidekick/ETC_Dimmer_Settings.
If you are using the Navis 100 Sidekick LED driver with a non-ETC dimmer,
the dimmer must be rated for use with LED/CFL fixtures.
Installation
Note:
electrical equipment.
Prepare the Ceiling
Cut a 120 mm (4-3/4 in) diameter hole in the ceiling to accommodate the
luminaire's mounting clamps and the Navis 100 Sidekick LED driver.
Note:
ceiling thickness of 0.5–20 mm (1/32–3/4 in).
Ensure that there is sufficient wire extending down through the ceiling
opening so that the luminaire and LED driver can be inspected and serviced
when needed. ETC recommends at least 50 cm (20 in) of wire.
Spacing for Wall Wash Luminaires
If you are installing luminaires with a wall wash trim plate, ETC recommends
that you allow minimum spacing as follows to obtain the best coverage:
• 61 cm (2 ft) between the wall and the center of a luminaire
• 91 cm (3 ft) center-to-center of adjacent luminaires
8
Installation must follow all national and local codes for
Navis 100 luminaire mounting clamps can accommodate a
etcconnect.com/Navis_100_
Sidekick Installation Guide
Advertisement
Table of Contents
