Using The Monitor; Using Solo - Roland M-200i V-mixer Owner's Manual

INPUT AFL This selects the point from the signal is sent from
CH1 through 32 to solo. If this is on, the post-pan
signal of the channel is sent. If this is off, the pre-
fader signal is sent.
OUTPUT AFL This selects the point from which the signal is sent
from MAIN, AUX, or MTX to solo. If this is on, the post-
fader signal of the channel is sent. If this is off, the
pre-fader signal is sent.
SOLO FOLLOWS If this is on, the solo of the AUX/MTX is turned on in
SENDS ON FADER tandem with "SENDS ON FADER." When the "SENDS
ON FADER" mode is turned off, solo is turned off.

Using the monitor

1.
Access the MONITOR FUNCTION screen.
2.
Move the cursor to the MONITOR SOURCE and press
[ENTER] to access the MONITOR SOURCE screen.
3.
Select the monitor source and press [ENTER].
The monitor signal is output from the output jacks to which
MONITOR OUT L/R are patched, and from the PHONES jack.
4.
Use "MONITOR LEVEL" or the "PHONES LEVEL knob" to
adjust the output level of the monitor.
By default, MONITOR L/R is patched to ASSIGNABLE
OUTPUT 9/10. You can use the output patchbay to
change the output destination. For details, refer to
"Editing the output patching" (p. 88).

Using solo

1.
At the MONITOR FUNCTION screen, adjust the "SOLO
LEVEL" setting
2.
At the top panel, press [SOLO] for the desired channel.
The signal of that channel is sent to solo buses and output
from the output jacks to which MONITOR OUT L/R are
patched and from the PHONES jack.
3.
At the MONITOR section, use the "LEVEL knob" or the
"PHONES LEVEL knob" to adjust the monitor output
level.
Solo is set to have the following priorities:
(High) 4 Key-in solo
3 CH
Priority
2 DCA solo
(Low) 1 MAIN, AUX, MTX
Solo operates under the following rules;
• Turning on a higher-priority solo temporary replaces
lower-priority solos. Operation returns to the lower-
priority solos when the higher-priority solo is cleared.
• Turning on a lower-priority solo clears higher-priority
solos.
Monitor/Solo
93