Error Message List - Roland M-200i V-mixer Owner's Manual

Appendix

Error message list

Message
xxx is used for EXT FXx
Do you want to disable it?
Cannot operate the USB memory.
It exceeds the power capability.
Internal battery is low.
Internal data were damaged.
M-200i starts with initialized setting.
Media is abnormal.
Media not formatted.
MIDI/RS-232C Rx Error
Framing.
MIDI/RS-232C Rx Error
Buffer Full.
REAC Error
Fan Stop.
REAC Error
Temp High.
REAC : Wrong sampling frequency.
The data is locked
The internal FAN has stopped.
USB MIDI Rx Error
Buffer Full.
LAN Rx Error
Buffer Full.
Could not make the wireless
connection.
This Access point is not supported.
WIRELESS LAN Rx Error
Buffer Full.
DOCK Rx Error
Buffer Full.
116
Explanation
Port xxx is being used by EXT FXx. Do you want to disable EXT FXx?
The device connected to the USB MEMORY connector used more than the maximum allowable electrical current.
The internal lithium battery has run down.
Data was initialized because the internal memory data was lost when the internal lithium battery was depleted
or was replaced.
The USB memory has malfunctioned.
The USB memory has not been formatted.
An inappropriate signal is being input to MIDI/RS-232C.
Too much data is being received via MIDI/RS-232C.
The cooling fan of the input/output unit connected to REAC has stopped.
The temperature of the input/output unit connected to REAC has become abnormally high.
A REAC device whose sampling frequency is not supported by the M-200i is connected to REAC.
You attempted to edit a locked scene or library item.
The cooling fan located on the bottom panel has stopped.
Too much data is being received via USB MIDI.
Too much data was received by the LAN function.
A connection cannot be established.
Troubleshooting (p. 117)
The access point is unsupported. Use WPS or WPS2 as the authorization scheme.
Too much data was received by the WIRELESS LAN function.
Too much data was received via the DOCK CABLE connector.