Editing Geq Parameters; Geq Edit Function Screen - Roland M-200i V-mixer Owner's Manual

Effects,GEQ,External effects

Editing GEQ parameters

GEQ EDIT screen
1.
Access the GEQ screen
2.
Move the cursor to the EDIT button for the desired GEQ
among "GEQ1-4" and press [ENTER].
The GEQ1-4 EDIT screen is displayed.
GEQ faders
1
For each frequency band, these adjust the amount of boost
or cut in a range of -15.0 dB to +15.0 dB.
Use the left and right cursor buttons to select the desired
fader.
The value of the fader you operate is shown above the faders
of the GEQ.
Noise may occur when you operate the GEQ faders, but this is
not a malfunction. While using the top panel faders to control
the GEQ, [MUTE] buttons flash for faders whose position is
anything other than 0.0dB. Pressing a flashing [MUTE] resets the
fader to the 0.0-dB position.
72

GEQ EDIT FUNCTION screen

1.
Access the GEQ EDIT screen for the desired channel.
2.
Press [FUNC] to access the GEQ EDIT FUNCTION screen.
The operations available at the GEQ EDIT FUNCTION screen are as
follows:
GEQ ON FADER When this is set to ON, you can controll a GEQ
using the top-panel faders (p. 73).
0.5dB STEP When this is set to ON, you can operate the GEQ
fader in steps of 0.5 dB.
SOURCE This sets the insert channel for the specified GEQ.
BYPASS This turns bypass on/off for the specified GEQ.
When these are on, the input signal will be "thru-
ed" to the output.
LINK This links the parameters between GEQ 1 and 2 (or
GEQ 3 and 4).
FLAT This sets the 31-band GEQ to a flat response.
COPY Copies GEQ settings to the clipboard.
PASTE When GEQ settings have been copied to the
clipboard, this pastes the settings from the
clipboard.
UNDO This undoes the last-performed parameter paste
operation. It is not displayed when there is no
action to undo.
LIBRARY Accesses the FX LIBRARY screen.
For information on COPY, PASTE, UNDO, LIBRARY go to "Basic
operation," and refer to "Copy" (p. 28), "Paste" (p. 29), "Undo"(p.
29), "Library" (p. 30).