Network; Network Functions; Network Settings - Roland M-200i V-mixer Owner's Manual

Network

Network functions

LAN
You can connect a Wireless LAN router to the LAN connector on
the M-200i's rear panel and use a application that has wireless
support (the M-200i Remote iPad application) to operate the M-
200i remotely.
WIRELESS LAN
You can use the WLAN ADAPTOR connector on the rear panel to
operate the M-200i remotely using an application that has
wireless support (the M-200i Remote iPad application).
Two methods are available: using a Wireless LAN router, and
connecting a Wireless device directly (ad-hoc mode) without
using a Wireless LAN router.

Network settings

You use the NETWORK screen to make network settings.
Accessing the NETWORK screen
1.
In the DISPLAY section, press [SETUP].
2.
At the SETUP screen, select "NETWORK" and press
[ENTER].
The NETWORK screen is displayed.
The following infomations are displayed:
1 LAN
Connection status
1
Indication Description
CONNECTED A LAN cable is connected
NOT CONNECTED No LAN cable is connected.
100
IP ADDRESS
2
This indicates the IP address.
SETUP button
3
This access the LAN screen.
2 WIRELESS LAN
Connection status
1
Indication Description
CONNECTED Connected to the Wireless LAN router.
NOT CONNECTED A wireless USB adapter is attached, but no
connection to a Wireless device is in effect.
NOT AVAILABLE No wireless USB adapter is attached.
AD-HOC Ad-hoc mode (p. 104).
Connection infomation
2
Mode Contents
Using a Wireless LAN Identifier (name) of the connected Wireless
router LAN router
Ad-hoc mode Ad-hoc SSID , Ad-hoc key (5 characters)
The ad-hoc SSID is set automatically when "WIRELESS ID" has
been specified at the WIRELESS LAN OPTION popup.
SETUP button
3
This access the WIRELESS LAN screen.