Pasting Channel Settings From The Clipboard; Undoing (Canceling) A Paste Operation - Roland M-200i V-mixer Owner's Manual

When using the COPY function on the AUX/MTX/MAIN CHANNEL
EDIT screen, the following parameters for the currently selected
channel are copied:
ATT Attenuator
Comp Compressor (when compressor is selected)
EQ 4-band EQ
Fader Fader
Balance Balance
Limiter Limiter (when limiter is selected)
Delay Delay
Group DCA groups, mute groups
To MAIN MAIN button/PAN (enabled only for AUX)
MTX AUX/MTX/MAIN bus mix
When using the COPY function on the GATE/EXPANDER screen,
COMPRESSOR/LIMITER screen, EQ screen, or SENDS screen, the
only contents of each respective function are copied.
Pasting channel settings from the
clipboard
Settings saved on the clipboard can be pasted. The paste
function is displayed only when settings are present on the
clipboard.
1.
At the editing screen for the desired channel, access the
FUNCTION screen.
2.
Move the cursor to "PASTE" and press [ENTER].
3.
The CHANNEL PASTE screen for selecting the content to
paste is displayed.
When individual settings for the COMPRESSOR/LIMITER screen
(p. 49), the EQ screen (p. 55), or the like have been copied, the
individual settings alone are pasted, with no screen for selecting
the content to paste displayed.
4.
Add check marks to the parameters that you want to
paste.
5.
Move the cursor to the PASTE button and press [ENTER].
A message announcing the completion of the paste operation is
displayed.
Pressing [EXIT] will cancel the operation.
When a mix of MTX has been pasted to MAIN/AUX, the levels
sent from the respective input channels to the copy-source MTX
bus are replicated at the paste-destination buses. However, the
sends from MAIN / AUX to MTX are not pasted.
Undoing (canceling) a paste
operation
This undoes the last-performed parameter paste operation.
The undo function is displayed only when pasted parameters
that can be undone exist.
1.
Access the CHANNEL FUNCTION screen for the desired
channel.
2.
Move the cursor to "UNDO" and press [ENTER].
A message announcing the completion of the undo
operation is displayed.
Basic operation
29