Metering; About The Meters; Meter Function Screen - Roland M-200i V-mixer Owner's Manual

Metering

About the meters

This section describes the METER screen, where you can view a
list of channel levels.
Accessing the METER screen
1.
In the top panel's DISPLAY section, press [METER].
fig.ScrMeter.eps
The METER screen is displayed.
You can view a list of the levels of the channels.

METER FUNCTION screen

To change the level detection point of the meter and make peak
hold settings, you use the METER FUNCTION screen.
1.
Access the METER screen.
2.
Press [FUNC] to access the METER FUNCTION screen.
The functions available at the METER FUNCTION screen are as
follows:
PEAK HOLD This turns the meter's peak hold function on/off.
PEAK HOLD TIME This sets the duration that the meter's peak hold or
OVER indication stays lighted, in a range of 1 sec to 4
sec or CONTINUE. Meter peak hold is enabled only
when the PEAK HOLD is on.
OVER LEVEL This adjusts the level at which the OVER indication of
the meter lights up, in a range of -18 dB to 0 dB.
CH METERING Use these to select the level detection point for the
POINT CH meters.
BUS METERING Use these to set the level detection point for the
POINT AUX/MTX/MAIN meters.
HOME Selects the unit's Home screen.
SCREEN
PEAK CLEAR Clears the level meter's peak hold or over indication.
For information on PEAK CLEAR, go to "Basic operation," and
refer to "Peak clear" (p. 33).
For information on HOME SCREEN, go to "User preferences ,"
and refer to "Selecting the Home screen" (p. 95).
59