Direct Monitor Mixer; Main Out 2 2; Sub Out 2 2; Output - Roland Sonar V-Studio VS-700 Owner's Manual

Direct Monitor Mixer

By using the Direct Monitor Mixer, input signals and signals from the internal sound generator can be output directly
to the monitor without being routed through the computer. The Direct Monitor Mixer is a stereo mixer that lets you
adjust parameters such as volume and pan for each input and audio source. As the output destination of the mixer,
you can select Main, Sub, or Digital 1 Out as desired. (You can also select more than one of these simultaneously.)
If you're using SONAR, you can edit the Direct Monitor Mixer parameters as described below.
If you're using software other than SONAR, use "VS-700R I/O Editor" which is included on the "SONAR V-
STUDIO 700 CD-ROM."
1.
From SONAR's "Tools" menu, open "VS-700."
2.
Select the "DIRECT MIX" tab.
3.
Apply the desired Direct Monitor Mixer
settings.
These settings are not stored in the VS-700.
Input Settings
Setting
Mono
Solo
Mute
Pan
Volume
Output Destination Settings
The output of the monitor mixer can be mixed to the following three audio outputs.
You can select multiple output destinations simultaneously, but the same signal will be output. If you're monitoring
through headphones, select Main or Sub.
Setting
Main output
Sub output
Digital output 1
86
Screen label State
MONO Stereo, Mono
SOLO OFF, ON
MUTE OFF, ON
PAN L (100%)–R (100%)
VOLUME -∞–+6 dB
Screen label State
MAIN OFF, ON
SUB OFF, ON
DIGITAL 1 OFF, ON
Explanation
The adjacent stereo pair will be mixed to a
monaural signal. If the input signal is a single
channel (monaural), use the MONO setting.
Solo within the monitor mix.
Mute within the monitor mix.
Adjust the pan within the monitor mix.
Monitor volume.
Explanation
Main output
Sub output
Digital output 1