System Settings; Formatting An Sd Memory Card; Sampling Frequency Setting - Roland SONAR V-STUDIO VS-100 Hardware Manual

System settings

Formatting an SD memory card

An SD memory card that you have just purchased or an SD
memory card that has been used by a computer or other
device must be formatted as described below before it can
be used with the SONAR V-STUDIO 100.
When you format an SD memory card, all data on that
card will be erased. Be sure to back up any important
data before you proceed.
If an SD memory card that is not in a state that can be
used by the SONAR V-STUDIO 100 is inserted, the
display will indicate "SD Unformatted."
1.
Hold down the [DISPLAY] button for approximately
one second to access the system setting screen.
2.
Turn the [CURSOR/VALUE] knob to move the cursor
to "SD Format," and then press the [CURSOR/
VALUE] knob.
fig.Format1.eps
3.
A confirmation screen appears.
To begin formatting, turn the [CURSOR/VALUE] knob to
highlight "Yes," and then press the [CURSOR/VALUE] knob.
fig.Format2.eps
If you decide not to format the card, turn the [CURSOR/
VALUE] knob to highlight "No," and then press the [CURSOR/
VALUE] knob.
* Do not remove the SD memory card until formatting has
been completed.
4.
When formatting has been completed, you will
return to the system setting screen.
52
5.
Press the [DISPLAY] button to return to the
previous screen.

Sampling frequency setting

If you want to connect the SONAR V-STUDIO 100 to your
computer via USB and use its USB audio interface
functionality, set the V-STUDIO's sampling frequency to
match your software's sampling frequency as follows.
1.
Hold down the [DISPLAY] button for approximately
one second to access the system setting screen.
2.
Turn the [CURSOR/VALUE] knob to move the cursor
to "Sample Freq," and then press the [CURSOR/
VALUE] knob.
fig.SetSampleFreq1.eps
3.
Turn the [CURSOR/VALUE] knob to specify the
desired sampling frequency, and then press the
[CURSOR/VALUE] knob to confirm the change.
fig.SetSampleFreq2.eps
4.
Turn the SONAR V-STUDIO 100's power off and
then on again.
The SONAR V-STUDIO 100's sampling frequency setting will
not change until the power has been turned off and on again.
If the SONAR V-STUDIO 100's actual sampling frequency
does not match the setting in the system setting screen,
an "*" symbol is shown by the sampling frequency
value.