Connecting To Alan With Static Ip Addresses; Entering Static Ip Address Parameters From A Telephone Keypad - Net2Phone Max 8 User Manual

Max 8 and 8 Plus User's Guide
2.2 Connecting to a LAN with Static IP
Addresses
This section explains how to connect your Web
browser to the Max 8 or Max 8 Plus if your LAN
uses static IP addresses, using either a telephone
keypad or serial connection. The process will
entail the following steps:
1. Disable DHCP in the Max 8 or Max 8 Plus.
2. Enter a static IP address.
3. Enter a net mask address.
4. Reset the Max 8 or Max 8 Plus.
5. Log in to the Max Web Manager.
6. Set the required configuration parameters in
the Max Web Manager.
2.2.1 Entering Static IP Address Parameters
from a Telephone Keypad
If your LAN uses static IP addresses, the most
practical way to set up the Max 8 or Max 8 Plus
is to enter an IP address and a net mask
address from a telephone keypad. You can
then finish setting up the unit while browsing
the Max Web Manager.
2.2.1.1 Disabling DHCP on the Max 8 or Max 8 Plus
from a Telephone Keypad
Since the Max 8 is shipped with DHCP enabled,
you need to disable DHCP to use static IP
Logging in to the Max Web
Manager.
16
Section 2