Net2Phone Max 8 User Manual page 27

Max 8 and 8 Plus User's Guide
2.2.1.4 Re-enabling DHCP from a telephone keypad
If you need to re-enable DHCP in the Max 8,
proceed as follows:
1.
2.
3.
3. If the new address is correct,
simply hang up the telephone. If
the new address is incorrect,
hang up the telephone and
repeat from step 1, above.
4. Reset the Max 8 to activate the
changes. To do this, power-off
the unit, wait 10 seconds, and
turn it on again.
The new net mask address is
now in effect.
If you are using static IP addresses,
you are now ready to finish setting
up the Max 8 using the Max Web
Manager. Proceed to Section 3,
Logging in to the Max Web Manager.
Lift the handset and dial
DHCP parameter code).
The voice prompt announces, "DHCP is
enabled now. Please press pound."
Press the pound key (#).
Reset the Max 8 as directed in Step 4 in
Section 2.2.1.2, above.
DHCP is now enabled.
***
4 (the enable
19
Section 2