Net2Phone Max 8 User Manual page 53

Max 8 and 8 Plus User's Guide
4.4.2.1 Configuring Max-to-Max Calling
Callers may access a port on a
remote Max 8 or Max 8 Plus from
another Max device (Max-to-Max) by
dialing *72 followed by the receiving
port's virtual number, which is the first
ten digits of its account number.
If the receiving port is an FXS port, the
telephone connected to the port will ring.
If the receiving port is an FXO port, it
permits callers to use its PBX as
though they were on a local PBX
telephone extension, subject to the
options set by the receiving unit's
system manager in its Max-to-Max
IVR Configuration Table. Callers must
use the remote PBX's dialing plan. For
example, if PBX users at the remote
site dial 9 for an outside line, the
callers must also do so.
The Max-to-Max IVR Configuration
Table allows the system manager to
configure the way a Max 8 or Max 8
Plus's FXO ports will respond to VoIP
calls it receives from other Max units.
In the Max-to-Max IVR Configuration
Table:
1. Make sure the FXO port you are
configuring is connected to the
analog line card on the PBX unit.
2. Select one of the following five
modes: (only one mode at a
time may be selected)
45
Section 4