Entering Static Ip Addresses Via Hyperterminal - Net2Phone Max 8 User Manual

Max 8 and 8 Plus User's Guide
The telephone keypad configuration parameter
codes are as follows:
Read IP address
Assign static IP address
Assign netmask
2.2.2 Entering Static IP Addresses via
HyperTerminal
Although many of the Max 8 and Max 8
Plus's IP parameters can be set manually
through the serial connection, if desired, this
section will only show you how to set the IP
address and netmask parameters. The
procedure is as follows.
2.2.2.1 Turning DHCP On (or Off) from
***1
***2
***3
HyperTerminal
The Max's default DHCP setting is
DHCP enabled. Before you can enter
a static IP address, you must first
disable DHCP (the same procedure is
used to re-enable it, if necessary).
1. Follow the procedures in
Section 2.1.2.1 above, Using
HyperTerminal, to start your
HyperTerminal connection.
2. After logging in:
a. From the root directory, type
NETUTIL followed by the
Enter key to move to the
network utility directory.
b. From the n2p:/netutil>
prompt, type dhcpd
20
DHCP disable ***5
DHCP enable ***4
Section 2