The Hardware Setup Procedure - Net2Phone Max 8 User Manual

Max 8 and 8 Plus User's Guide
1.3.3

The Hardware Setup Procedure

1.3.3.1 The Hardware Installation Guide
1.3.3.2 Steps in the Hardware Setup
connected to the PBX or to an
analog telephone.
NOTE: On the Max 8 Plus without FXS ports
installed, the LAN settings must be
configured using a PC with a serial cable
connection. For details see Section 2.1.2,
Connecting to the Max 8 Plus Through a
Serial Cable in this Guide.
A Hardware Installation Guide that
describes hardware installation,
cabling, and safety-related issues was
provided along with your Max 8 unit.
Please read that manual in its entirety
before beginning your hardware
installation. Make sure you completely
understand the issues discussed and,
in particular, the safety warnings given.
Procedure
The steps you will follow to set up your
Max 8 and Max 8 Plus are:
1. Install the Max 8 or Max 8 Plus
unit in its location and connect
the cabling.
2. Configure the LAN settings on
the Max 8 or Max 8 Plus so that
it communicates with your LAN.
3. Log in to the Max Web Manager.
4. Finish configuring your FXS
ports via the Web Manager.
5
Section 1