Net2Phone Max 8 User Manual page 39

Max 8 and 8 Plus User's Guide
more packet loss. However, packet delay
increases with the bounds size. The default values
in this table should not normally be changed.
DHCP users: If your LAN is using DHCP
addresses, you do not have to configure this page.
You may proceed directly to Section 4.3,
Configuring Accounts, below.
Static address users: Your IP address and
netmask are already present in the IP Configuration
table (you entered them previously). Now you need
to enter the additional IP parameter information you
obtained from your LAN administrator:
? ? Default Gateway
? ? DNS Server IP (Primary)
? ? DNS Server IP (Secondary)
? ? Domain Name (if applicable)
NOTE: If a default gateway address or a DNS
server address is not used, the value 0.0.0.0 must
be entered into their respective boxes. If the boxes
are left blank, the modified configuration settings
will not be saved.
The Network Configuration table displays the
doorman IP addresses and ports, and the
TCP/UDP start ports.
The Port Numbers parameters must be changed
to permit access when a LAN's firewall permits
only pre-assigned TCP/UDP port numbers to be
used.
31
Section 4