Net2Phone Max 8 User Manual page 23

Max 8 and 8 Plus User's Guide
2.1.2.2 Obtaining the Max's DHCP IP
appears. You are now logged in.
NOTE:
·
The Max 8 and Max 8 Plus allow only
three management user names. You
can change any user's password, but
you cannot delete or create additional
users.
·
User names and passwords are
CASE SENSITIVE.
Address via HyperTerminal
If your LAN uses static addresses,
refer to Section 2.3, Entering Static
IP Addresses via HyperTerminal.
1. Make a serial connection from
your computer to the Max 8
(refer to Section 2.1.1, above.)
2. After logging in to the Max 8,
type /config/ip at the
command prompt.
The active directory changes to
/config/ip and the prompt
becomes MAX:/config/ip>.
3. Type show, followed by the
Enter key.
The current IP parameters are
listed on the screen.
4. Scroll up with the arrow key, if
necessary, to see the parameter
listing.
You are now ready to finish
setting up the Max 8 or Max 8
Plus using the Max Web
Manager. Proceed to Section 3,
15
Section 2