Net2Phone Max 8 User Manual page 26

Max 8 and 8 Plus User's Guide
3. If the new address is correct, simply hang
4. Reset the Max 8 or Max 8 Plus to activate
You are now ready to finish setting up the Max 8
using the Max Web Manager. Proceed to
Section 3, Logging In to the Max Web Manager.
2.2.1.3 Entering a Netmask Address from a
For example, if you want to enter the IP
address "192.168.172.19", you would
enter 192*168*172*19# from your
telephone keypad.
The voice prompt responds, "Your
address is..." and repeats the address you
entered.
up the telephone. If the new address is
incorrect, hang up the telephone and
repeat from step 1, above.
the changes. To do this, power-off the unit,
wait 10 seconds, and turn it on again.
DHCP is now disabled.
Telephone Keypad
To enter a netmask address:
1. Lift the handset and dial
(the netmask parameter code).
The voice prompt responds,
"Please enter your netmask."
2. Dial the numbers for the
netmask address you wish to
enter on the telephone keypad.
Use the star key (*) to replace
the periods in the address and
end with the pound key (#).
The voice prompt responds,
"Your netmask is..." and repeats
the address you entered.
18
Section 2
***
3