Connecting To Alan With Static Ip Addresses; Entering Static Ip Addresses From A Telephone Keypad - Net2Phone MAX 410 User Manual

Net2Phone MAX 410/420/430 User GuideSection 2.2 – Connecting to a LAN with Static IP Addresses
2.1.2.2 Obtaining the MAX's DHCP IP address via HyperTerminal
If your LAN uses static addresses, refer to Section 2.2 in this Guide, Entering Static IP
Addresses via HyperTerminal.
1. Make a serial connection from your computer to Net2Phone MAX 410 (refer to Section
2.1.1, above.)
2. After logging in to the MAX 410, type
active directory changes to
n2p:/config/ip>
3. Type
the screen. Write them down and keep them for future reference.
If your LAN uses DHCP, you are now ready to finish setting up the Net2Phone MAX
410/420/430 using the MAX Web Manager. Proceed to Section 3, Logging In to the MAX
Web Manager.
2.2 Connecting to a LAN with Static IP Addresses
This section explains how to connect your Web browser to the Net2Phone MAX 410/420/430 if your
LAN uses static IP addresses, using either a telephone keypad or serial connection. The process will
entail the following steps:
1. Disable DHCP in the MAX 410/420/430.
2. Enter a static IP address.
3. Enter a netmask address.
4. Reset the unit.
5. Log in to the MAX Web Manager.
6. Set the required configuration parameters in the MAX Web Manager.

2.2.1 Entering Static IP addresses from a Telephone Keypad

If your LAN uses static IP addresses, the most practical way to set up the MAX 420 is to enter
an IP address and netmask from a telephone keypad. You can then finish setting up the unit
while browsing the MAX Web Manager.
2.2.1.1 Disabling DHCP from a telephone keypad (MAX 420/430)
Since the Net2Phone MAX 410/420/430 is shipped with DHCP enabled, you need to disable
DHCP to use static IP addresses. To disable DHCP, proceed as follows:
1. Connect an analog telephone to any RJ-11 port on the MAX 410/420/430.
2. Lift the handset and dial
announces, "DHCP is disabled now. Please press pound".
3. Press the pound key (#).
4. Hang up the telephone.
DHCP is now disabled.
2.2.1.2 Entering an IP address from a telephone keypad (MAX 420/430)
Ask your LAN administrator for the IP address that will be assigned, the LAN's netmask
address, domain name, and any other IP parameters that can be provided.
/config/ip
.
c followed by the R key. The MAX 410's IP address and netmask are listed on
***
5 (the disable DHCP parameter code). The voice prompt
Page 11
/config/ip at the command prompt. The
and the prompt becomes