Net2Phone Max 8 User Manual page 21

Max 8 and 8 Plus User's Guide
then be completed more easily via the Max
Web Manager.
2.1.2.1 Using HyperTerminal
Figure 4 – Max 8 and 8 Plus Serial Connection
For this procedure you will need a
standard serial cable (D-sub 9-pin,
male-to-female, straight -through
connection) as shown in Figure 4, and a
PC or Mac running the HyperTerminal
terminal-emulator program (or an
equivalent), which is included in
Microsoft operating systems. It is usually
found in the Programs menu, under
Accessories.
NOTE: If your Max 8 Plus does not have any
FXS ports installed, its LAN settings can
only be configured using this method.
1. With the power to the Max 8 or
Max 8 Plus turned OFF, connect
the cable from the unit's serial or
console port to one of the PC's
serial ports. Note which of the
PC's serial ports you are using.
2. Launch HyperTerminal and set up
a new connection.
3. In the dialog box, specify the
appropriate serial port, and set the
serial communication parameters
as follows:
13
Section 2