Net2Phone Max 8 User Manual page 25

Max 8 and 8 Plus User's Guide
addresses. To disable DHCP, proceed as
follows:
1. Connect an analog telephone to any RJ-
2. Lift the handset and dial
3. Press the pound key (#) (Important!).
4. Hang up the telephone.
2.2.1.2 Entering an IP address from a Telephone
Keypad
Ask your LAN administrator for the IP address
that will be assigned, the LAN's net mask
address, domain name, and any other IP
parameters that can be provided.
To enter the IP address:
1. Lift the telephone handset and dial
2. Dial the numbers for the IP address you
11 port on the Max 8 or Max 8 Plus.
NOTE: To use this method for the Max 8
Plus, there must be an FXS card installed.
DHCP parameter code).
The voice prompt announces, "DHCP is
disabled now. Please press pound".
DHCP is now disabled.
(the IP address parameter code).
The voice prompt responds, "Please enter
your IP address."
wish to enter on the telephone keypad.
Use the star key (*) to replace the periods
in the address and end with the pound key
(#).
17
Section 2
***
5 (the disable
***
2