Obtaining The Max's Dhcp Ip Address Via Hyperterminal; Connecting To Alan With Static Ip Addresses - Net2Phone Max 410 User Manual

Max 410/420/430 User's Guide – Chapter 3
NOTE:
The Max 410/420/430 provides
three fixed user (or manager)
names. You can change any
manager's password, but
managers cannot be created,
deleted, or renamed.
Manager names and passwords are
case sensitive.
Obtaining the Max's DHCP IP address via
HyperTerminal
If your LAN uses static addresses, refer to Entering
Static IP Addresses via HyperTerminal on page 21 in
this Guide.
1. Establish a serial connection from your computer
to the Max 410 (refer to Using the
HyperTerminal Emulation Program on page 18
in this Guide.)
2. After logging in to the Max 410, type
/config/ip at the command prompt.
The active directory changes to /config/ip
and the prompt becomes n2p:/config/ip>.
3. Type S followed by the Enter key.
The Max 410's IP address and netmask are listed
on the screen. Write them down and keep them
for future reference.
If your LAN uses DHCP, you are now ready to finish
setting up the Max 410/420/430 using the Max Web
Manager. Proceed to Chapter 4, Logging Into the Max
Web Manager.
Connecting to a LAN with Static IP
Addresses
This section explains how to connect your Web browser to
the Max 410/420/430 if your LAN uses static IP
21