Max 8 and 8 Plus User's Guide
Figure 6 – LAN Parameters in HyperTerminal
3. At the Enter <parameter>:
prompt, enter 2 to change the
Netmask.
4. When you finish making
changes, reset the Max 8 or
Max 8 Plus to activate the
changes. You may either:
? ? type /system/reset at
the command line, or
? ? power-off the unit, wait 10
seconds, and turn it on
again.
5. (Optional) Ping the Max from a
PC, as illustrated in Figure 7
below, using the new IP address,
to confirm that the correct
parameters have been entered
and stored successfully.
22
Section 2