Max 8 and 8 Plus User's Guide
4.4.2
The Max-to-Max IVR Configuration Table
If your unit does not have FXO ports or will not
be receiving any Max-t o-Max calls, this section
is not applicable.
Click the Max-to-Max IVR Config link on the
Site Map page to go to the Max-to-Max IVR
Configuration Table, illustrated below.
Figure 17 – Max-to-Max IVR Configuration
NOTE:
? ? If the LAN to which either Max is
connected employs a firewall, you need
to configure settings on both the Max
unit and the firewall before you can
place Max-to-Max calls.
? ? For information about configuring a
firewall, refer to Section 4.2,
Configuring Firewalls. In Max-to-Max
calling, the receiving port's Account
Information table settings must be
configured to permit it to receive calls.
For details, refer to Section 4.4.2.2,
Receiving Max-to-Max Calls.
44
Section 4