3-44
ENGINE
GENERATOR
INSPECTION (9-10)
REASSEMBLY
• When installing the generator stator set bolts, tighten them to
the specified torque.
Generator stator set bolt: 11 N·m (1.1 kgf-m, 8.0 lb-ft)
NOTE:
Be sure to install the grommet 1 to the generator cover.
WATER PUMP
7-11
GEARSHIFT SYSTEM
GEARSHIFT SHAFT/GEARSHIFT ARM DISASSEMBLY
• Remove the following parts from the gearshift shaft/gearshift
arm.
1 Washer
2 Snap ring
3 Gearshift shaft return spring
4 Gearshift cam drive plate
GEARSHIFT SHAFT/GEARSHIFT ARM INSPECTION
• Inspect the gearshift shaft/gearshift arm for wear or bend.
• Inspect the return springs for damage or fatigue.
• Replace the arm or spring if there is anything unusual.
GEARSHIFT SHAFT/GEARSHIFT ARM REASSEMBLY
• Apply THREAD LOCK to the gearshift shaft screw.
99000-32050: THREAD LOCK "1342"
NOTE:
When installing the gearshift shaft return spring, position the
stopper A of gearshift arm between the shaft return spring ends
B .
5 Plate return spring
6 Washer
7 Screw