Starter Clutch And Generator Rotor - Suzuki DR-Z400S 2001 Service Manual

Tighten the crankcase bolts to the specified torque.
Crankcase bolt: 11 N·m (1.1 kgf-m, 8.0 lb-ft)
After the crankcase bolts have been tightened, check if the
crankshaft, countershaft, and driveshaft rotate smoothly. If a
large resistance is felt to rotation, try to free the shafts by
tapping them with a plastic mallet.
STARTER CLUTCH AND GENERATOR
ROTOR
Remove the grease from the tapered portion of the crank-
shaft and the generator rotor.
Install the starter clutch gear 1 and key 2.
Tighten the generator rotor nut to the specified torque using a
26 mm offset wrench.
Generator rotor nut: 100 N·m (10.0 kgf-m, 72.5 lb-ft)
ENGINE 3-51
1
2