5) If OK, then check the continuity between each terminal and
ground.
Injector continuity: ∞ Ω (Infinity)
09900-25008: Multi-circuit tester set
Tester knob indication: Resistance (Ω)
Are the resistance and continuity OK?
YES
Go to Step 2.
NO
Replace the injector with a new one. (5-23)
6) After repairing the trouble, clear the DTC using SDS tool.
(4-27)
Step 2
1) Turn the ignition switch ON.
2) Measure the injector voltage between Y/R wire and ground.
Injector voltage: Battery voltage
NOTE:
Injector voltage can be detected only 3 seconds after ignition
switch is turned ON.
09900-25008: Multi-circuit tester set
Tester knob indication: Voltage ()
(+ Y/R – - Ground)
FI SYSTEM DIAGNOSIS
1
2
4-81
V