Brake Fluid Replacement - Suzuki GSX-R750 Service Manual

8-66 CHASSIS
• Install the spring to the caliper, bring its wider side of pawl A
facing top.
• Install the new brake pads.
• Install the brake caliper.
• Tighten each bolt to the specified torque.
 Pad mounting pin 1: 15 N·m (1.5 kgf-m, 11.0 lb-ft)
Front brake caliper mounting bolt 2:
NOTE:
After replacing the brake pads, pump the brake lever a few times
to check for proper brake operation and then check the brake
fluid level.

BRAKE FLUID REPLACEMENT

• Place the motorcycle on a level surface and keep the handle-
bars straight.
• Remove the brake fluid reservoir cap 1 and diaphragm.
• Drain the old brake fluid as much as possible.
• Fill the reservoir with new brake fluid.
• Connect a clear hose to the caliper air bleeder valve and
insert the other end of hose into a receptacle.
• Loosen the air bleeder valve and pump the brake lever until
old brake fluid flows out of the bleeder system.
• Close the caliper air bleeder valve and disconnect a clear
hose. Fill the reservoir with new fluid to the upper mark of the
reservoir.
 Specification and classification: DOT 4

Bleed air from the brake system. (2-23)
35 N·m (3.5 kgf-m, 25.5 lb-ft)