Suzuki GSX-R750 Service Manual page 146

*1: Direction of outside
DRIVE PLATE:
a No. 2 Drive plate .......1 pc. [Black paint/I.D. 111 mm (4.4 in)]
b No. 1 Drive plate .......7 pcs. [Purple paint/I.D. 111 mm (4.4 in)]
c No. 3 Drive plate .......1 pc. [NIL/I.D. 118 mm (4.6 in)]
NOTE:
No.3 drive plate can be distinguished by the inside diameter
(I.D.).
DRIVEN PLATE: (d + e = Total 8 pcs.)
d No. 1 Driven plate (Thickness): 2.0 mm (0.102 in).....6 – 8 pcs.
e No. 2 Driven plate (Thickness): 1.6 mm (0.091 in).....2 – 0 pcs.
• Install the pressure plate H.
NOTE:
When install the pressure plate, fit the convex part D of the
pressure plate onto the concave part E of the clutch sleeve hub.
• Install the clutch springs.
• Hold the clutch housing with the special tool.

Be careful not to damage the clutch housing or clutch
plates.
 09920-53740: Clutch sleeve hub holder
• Tighten the clutch spring set bolts to the specified torque.
 Clutch spring set bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
NOTE:
* Tighten the clutch spring set bolts diagonally.
* After mounting the engine, adjust the push rod. (  2-16)
*2: Paint
*1
*2
or
ENGINE 3-93