Suzuki GSX-R750 Service Manual page 155

3-102 ENGINE
• Tighten the valve timing inspection cap 2 to the specified
torque.
 Valve timing inspection cap: 11 N·m (1.1 kgf-m, 8.0 lb-ft)
CYLINDER HEAD COVER
• Pour engine oil in each oil pocket in the cylinder head.
NOTE:
Be sure to check the valve clearance. (  2-7)
• Install the PAIR reed valves 1 along with the gaskets.
NOTE:
Fit the projection of the gaskets to the depression of the cam-
shaft holders.

Replace the gaskets with new ones.
• Install a new gasket to the cylinder head cover.
• Apply SUZUKI BOND to the cam end cap points of the gasket
as shown.
 99000-31140: SUZUKI BOND "1207B"

Use a new gasket to prevent oil leakage.
• Place the cylinder head cover on the cylinder head.
• Fit a new gasket 2 to each head cover bolt.

Use new gaskets to prevent oil leakage.