Matrix Vision System Manual page 209

• The recording is now going on. Whatever you speak on the phone is being recorded.
• Replace the handset as soon as the message is over. You may use your hand to press the hook switch to
reduce the delay.
• You will get ring because you are in programming mode.
• To verify the recording, issue command: 1406-Part Number, where M is the same message you gave earlier.
• Listen to the whole message.
• Repeat above procedure if you are not satisfied with the message.
Recording from an external source:
• The simple method described above is good enough for most of the applications. But if a better quality of
voice message is required, we need to eliminate all the room noise picked up by the phone while recording.
• A better option is supported by Vision to record high quality message. We need a cassette or CD player with
pre-amplified output port. This can be done as follows:
• Select the piece of music or message you want to record.
• Get this message recorded with the proper media.
• Select the track or the position on the media so that when you press PLAY, the desired message should
start without delay.
• Connect the player with the Vision using an audio cable.
• The external music source can be connected to the music port.
• Enter in the programming mode from a station.
• Issue command: 1404-1.
• Issue command: 1405-Part Number.
• You will hear confirmation tone.
• Start the player as soon as the confirmation tone stops on the phone.
• The recording has started.
• Replace the handset as soon as the message is over. You may use your hand to press the hook switch to
reduce the delay.
• You will get ring because you are in the programming mode.
• Stop the music source.
• To verify the recording, issue the command: 1406-Part Number.
• Listen to the whole message.
• Repeat the above procedure if you are not satisfied with the message.
Example:
Voice module is to be used for emergency call.
Solution:
1. Divide the voice module in one part using command 1403-01.
2. Record an Emergency message using command 1405-00.
3. Verify the recorded message using command 1406-00.
4. Assign Emergency call application to the voice module partition using command 1407-11-00.
Important Points:
• It is possible to use the voice module for multiple applications. However, only one application shall work at a
time.
• If the system is used with default VM config then on issuing command 1103-SE Password-Reverse SE
Password, default VM config is reloaded and voice message application works as before.
• However, if VM is programmed with customized message and if command 1103-SE Password-Reverse SE
Password is issued then voice messages will not be erased but the VM config would set to default settings.
To restore the VM config following command should be issue:
• 1403-Number of parts
• 1407-Voice Message Application-Part Number
Vision System Manual
Matrix
209