Matrix Vision System Manual page 192

Matrix
How to program?
Step 1: Decide number of Trunk Access Groups to be formed. Program these groups using command 4402.
Step 2: Program rotation code to select a trunk within the trunk access group using command 4403.
Step 3: Set a Trunk Access Group to default settings using command 4401 (if required).
Step 4: Assign a trunk access group and a trunk access code to a station for day time.
Step 5: Assign a trunk access group and a trunk access code to a station for night time.
Step 1
Use following command to put trunks in a trunk access group:
4402-1-Trunk Access Group-Trunk0.....Trunk2/#
Where,
Trunk Access Group is from 0 to 7.
Trunk0..Trunk2 are the software port numbers of the trunks from 0 to 2.
Use following command to put same trunks in all trunk access groups:
4402-*-Trunk0....Trunk2/#
Trunk Access
Trunk allowed
Group
0
1
2
3
4 No trunk
5 No trunk
6 No trunk
7 No trunk
Step 2
Use following command to program rotation code for a group:
4403-1-Trunk Access Group-Rotation Code
Where,
Roatation Code Meaning
Trunk rotation OFF within the group, system always
0
selects the first trunk from the group
1 Trunk rotation ON within the group
Use following command to program same rotation code for all the groups:
4403-*-Rotation Code
By default, Trunk Rotation is ON within the group.
Step 3
Use following command to default a trunk access group:
4401-1-Trunk Access Group-#
Where,
Trunk Access Group is from 0 to 7.
Use following command to default all trunk access groups:
4401-*-#
Step 4
Vision offers maximum 4 trunk access codes viz. 0, 5, 61 and 62. These codes are common for all the station
192
Trunk Access Code (both
daytime and nighttime)
0, 1, 2
0
1
2 No code assign
No code assign
No code assign
No code assign
No code assign
0 and 5
61
62
Vision System Manual