Matrix Vision System Manual page 208

Matrix
Step 5
Use following command to playback the recorded VM partition:
1406-Part Number
Where,
Part Number is from 00 to 15.
Step 6
Use following command to assign an application to a VM partition:
1407-Voice Message Application-Part Number
Where,
Part Number is from 00 to 15.
Voice Message Application
00
01
02
03
04
05
06
07
08
09
10
11
12
Use following command to de-assign application from a VM partition:
1407-Voice Message Application-#
Step 7
Use following command to set default values for all the VM parameters:
1401-#
On issuing this command VM config is changed as follows:
1. VM duration = 240 seconds.
2. Number of VM parts = 13.
3. Recording source = Telephone.
4. Assignment of Voice Message Application to part number = As shown to the table.
How to record/verify a voice message?
Recording from a telephone:
This method is very simple. Whatever we speak on the phone is recorded. It is done as follows:
• Select a good quality extension with good telephone.
• Request a person with clear voice to record the message in his or her voice.
• Select a peaceful place. Switch OFF fans and other sources of noise.
• Avoid room noise to maintain clarity of the message.
• Enter in the programming mode from this extension.
• Issue command 1404-0.
• You will get confirmation tone.
• Issue command 1405-Part Number.
• Start recording your message.
208
Meaning
Day Greeting
Night Greeting
Initial Guidance Message
Dial by Name Message
No Dial Message
Wrong Dial Message
Transfer Message
Busy Message
No Reply Message
Music on Hold
Alarm
Emergency Message
Auto Redial
Vision System Manual