Matrix Vision System Manual page 201

Matrix
Trunk Inter Digit Wait Timer
Trunk Inter Digit Wait Timer-This timer signifies the time for which the Vision waits between accepting two
digits from the caller. This timer is loaded when the caller dials first digit (digit could be other then station
number) and waits for the second digit, while reaching a desired station.
Command : 3011-Seconds
Default : 6 seconds.
Valid Range : 000 to 255 seconds.
Pause Timer
Pause Timer-It is the time for which the system waits before dialing the outside number after grabbing the
trunk. Some times it is observed that after grabbing the trunk line, the user does not get PSTN dial tone
immediately. Instead he gets the dial tone from the PSTN after some time. This is due to old types of PSTNs.
When user himself is dialing the number, he inadvertently waits for the dial tone and then dials the number. But
this is not so when PBX dials the number. When Redial or Auto Redial or Abbreviated Dialing feature is used
the PBX grabs the trunk line and dials the number at its own. Now if there is no pause time and if the PSTN is
old type then it is possible that the PBX may dial out the number before getting the dial tone. This may result in
dialing wrong number. To avoid this situation, Vision offers pause timer, which can be set for individual trunks.
Pause timer is used during Redial, auto Redial and Memory Dialing.
Command : 3012-Seconds
Default : 3 seconds.
Valid Range : 000 to 255 seconds.
Print commands
Use following command to print Trunk Parameters of a trunk:
3100-1-Trunk
Where,
Trunk is trunk software port number from 0 to 2.
Use following command to print Trunk Parameters of all trunks:
3100-*
201
Vision System Manual