Dell 5110cn Service Manual page 427

RRP7.11 ACTUATOR SENSOR 2 (PL7.2.7)
Since the four ACTUATOR SENSORS 2 are to be removed in the same manner, the
removal procedure is described for one of them only.
[Removal]
1) Remove TOP COVER FRAME. (RRP1.1)
2) Remove RIGHT SIDE COVER. (RRP1.7)
3) Remove LEFT SIDE COVER. (RRP1.12)
4) Remove COVER ASSY REAR. (RRP1.5)
5) Remove HIGH VOLTAGE POWER SUPPLY (HVPS). (RRP9.9)
6) Remove TONER DISPENSER ASSEMBLY. (RRP7.4)
7) Remove DISPENSER ASSY. (RRP7.5, 7.6, 7.7 or 7.8)
8) Release the hooks, at two locations, fixing BRACKET SENSOR 2 to DISPENSER ASSY with a
miniature screwdriver, remove the BRACKET SENSOR 2
9) Opening the hooks of BRACKET SENSOR 2, remove the ACTUATOR SENSOR 2.
[Replacement]
1) Attach ACTUATOR SENSOR 2 to BEACKET SENSOR 2.
2) Attach BRACKET SENSOR 2 to DISPENSER ASSY.
3) Attach DISPENSER ASSY. (RRP7.5, 7.6, 7.7 or 7.8)
4) Attach TONER DISPENSER ASSEMBLY. (RRP7.4)
5) Attach HIGH VOLTAGE POWER SUPPLY (HVPS). (RRP9.9)
6) Attach COVER ASSY REAR. (RRP1.5)
7) Attach LEFT SIDE COVER. (RRP1.12)
8) Attach RIGHT SIDE COVER. (RRP1.7)
9) Attach TOP COVER FRAME. (RRP1.1)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 177