REGISTRATION CHUTE ASSEMBLY (PL4.1.20)
Before staring the following work, cover the entire DEVELOPER ASSEMBLY with paper
or the like so as to prevent toner in DEVELOPER ASSEMBLY from adhering on your
Remove REGISTRATION ASSEMBLY. (RRP4.6)
Disconnect the connector (P/J18) of the MACHINE CONTROL UNIT (MCU) (PL9.1.16).
Remove the harness of the HARNESS ASSY REGISNS (PL4.1.4) from the harness guide of
A little lift up the rear part of REGISTRATION CHUTE ASSEMBLY and pull it out backward
Put the three hooks of front part of REGISTRATION CHUTE ASSEMBLY into the holes at
three locations in the printer frame, thrust the projections at two locations on the rear part of
REGISTRATION CHUTE ASSEMBLY into the mounting holes at two locations and attach it.
Lay the harness of the HARNESS ASSY REGISNS to the harness guide of the printer.
Connect the connector (P/J18) of the MACHINE CONTROL UNIT (MCU).
Be sure to remove the paper covering DEVELOPER ASSEMBLY.
Attach REGISTRATION ASSEMBLY. (RRP4.6)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 83