Exiting Digital Input (Di) Test; How To Check Sensors And Switches - Dell 5110cn Service Manual

4.2.3 Exiting digital input (DI) test

1) Press "CANCEL" key to stop the DI Test.
2) Press "MENU" key to exit the DI Test mode. ("IOT Diag" and "Digital Input" are displayed
after that "Please Wait" was displayed.)
3) Press "CANCEL" key, "IOT Diag" is displayed.
To shift the mode from Diag. mode to the normal mode, perform as follows.
4) Press " " key to select "Complete".
5) Press " " key three times to exit the "Diag. Mode."

4.2.4 How to check sensors and switches

- Parts Location
Toner Cartridge Sensor K
[DI-b]
Toner Cartridge Sensor C
[DI-a]
Toner Cartridge Sensor M
[DI-9]
Toner Cartridge Sensor Y
[DI-8]
Full Stack Sensor
[DI-0]
Exit Sensor
[DI-2]
DUP Jam Sensor
[DI-1]
BTR Toner Full
[DI-23]
REGI Sensor
[DI-3]
MSI No Paper
[DI-10]
No Toner Sensor Y
[DI-18]
No Toner Sensor M
[DI-19]
No Toner Sensor C
[DI-1A]
2 - 16
Chapter 2 Operation of Diag.
No Toner Sensor K
[DI-1B]
Interlock Open
[DI-7]
Tray 1 No Paper
[DI-11]
Cassette 1 Size
[DI-38]
Refer to 4.2.1
Refer to 4.2.1
Refer to 4.2.1
Refer to 4.2.1
Refer to 4.2.1
Refer to 4.2.1
Ten02001KA