RRP9.10 OPTION HDD ASSY (PL9.1.25)
Remove PAPER TRAY COVER. (RRP3.2)
Remove three SCREW KNURLING (PL9.1.32) and a screw (silver, 6mm) that fix ESS ASSY
to the printer.
Holding two handles of the ESS ASSY, draw it out.
Remove the two SCREW KNURLING that fix the OPTION HDD ASSY (PL9.1.25) to the ESS
Lift up the OPTION HDD ASSY to disconnect the connector, remove the OPTION HDD ASSY
from the ESS ASSY.
Match the two bosses of the OPTION HDD ASSY with the holes of the PLATE ASSY REAR
(PL9.1.2), connect the connector of the CONTROLLER CARD (PL9.1.3) and the connector of
the OPTION HDD ASSY.
Attach the OPTION HDD ASSY to the ESS ASSY using the two SCREW KNURLING.
Insert ESS ASSY into the printer, attach the connectors of CONTROLLER CARD and
MACHINE CONTROL UNIT (MCU). (PL9.1.16)
Attach CONTROLLER CARD to the printer using two SCREW KNURLING and a screw
Attach PAPER TRAY COVER. (RRP3.2)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 213