Dell 5110cn Service Manual page 341

RRP4.7 ROLL REGI METAL. (PL4.2.3)
[Removal]
1) Remove REGISTRATION ASSEMBLY. (RRP4.6)
2) Remove the two SPRING REGI from the left and right sides of the PLATE REGI.
3) Remove the left and right sides of the PLATE REGI.
4) Remove the E-ring that fixes the right side shaft of ROLL REGI METAL to CHUTE REGI,
remove BEARING METAL R.
5) Remove the E-ring that fixes GEAR REGI METAL to ROLL REGI METAL, remove GEAR
REGI METAL.
6) Remove BEARING METAL L that fixes the left side shaft of ROLL REGI METAL to CHUTE
REGI.
7) Shift ROLL REGI METAL from CHUTE REGI to the left, remove it upward.
[Replacement]
1) Attach ROLL REGI METAL to CHUTE REGI.
2) Insert BEARING METAL L into the left side shaft of ROLL REGI METAL.
3) Insert GEAR REGI METAL into the left side shaft of ROLL REGI METAL and fix it using the
E-ring.
4) Insert ROLL REGI METAL into the right side shaft of ROLL REGI METAL and fix it using
the E-ring.
Pay attention to fitting direction of the PLATE REGI and the SPRING REGI.
5) Attach the PLATE REGI to the left and right sides of the BEARING METAL L,R.
6) Hang the SPRING REGI on the left and right sides of the PLATE REGI, fix the PLATE REGI.
7) Attach REGISTRATION ASSEMBLY. (RRP4.6)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 91