Dell 5110cn Service Manual page 429

RRP7.12 TONER CARTRIDGE SENSOR (PL7.2.12)
[Removal]
1) Remove TOP COVER FRAME. (RRP1.1)
2) Remove RIGHT SIDE COVER. (RRP1.7)
3) Remove LEFT SIDE COVER. (RRP1.12)
4) Remove COVER ASSY REAR. (RRP1.5)
5) Remove HIGH VOLTAGE POWER SUPPLY (HVPS). (RRP9.9)
6) Remove TONER DISPENSER ASSEMBLY. (RRP7.4)
7) Remove DISPENSER ASSY (Y), (M), (C), (K). (RRP7.5, 7.6, 7.7 or 7.8)
8) Remove the connector (P/J342) from COIL ASSY CRUM READER (PL7.2.14). Remove the
harness from the harness guide on HSG BASE CRUM (PL7.2.15).
[Replacement]
1) Attach the connector (P/J342) to COIL ASSY CRUM READER. Pass the harness through the
harness guide on HSG BASE CRUM.
2) Attach DISPENSER ASSY (Y), (M), (C), (K). (RRP7.5, 7.6, 7.7 or 7.8)
3) Attach TONER DISPENSER ASSEMBLY. (RRP7.4)
4) Attach HIGH VOLTAGE POWER SUPPLY (HVPS). (RRP9.9)
5) Attach COVER ASSY REAR. (RRP1.5)
6) Attach LEFT SIDE COVER. (RRP1.12)
7) Attach RIGHT SIDE COVER. (RRP1.7)
8) Attach TOP COVER FRAME. (RRP1.1)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 179