Vlan - Fujitsu PRIMERGY RX600 S4 User Manual

4.6.4 VLAN

Notes
Note the following points when using a VLAN.
• When adding or deleting a VLAN, always use "Intel
from the [Device Manager] or [Network and Dial-up Connections].
• Up to ten VLANs can be set to a single LAN port.
• Up to four VLANs with "NetBIOS over TCP/IP" enabled are available throughout the system.
• On a VLAN, only use TCI/IP protocols. Do not use other protocols.
• When LLC and the LNDFC protocols are installed by the Fujitsu communication control service,
these protocols are bound (connected) unconditionally. Therefore, release the bind of VLAN and
these protocols in the system where these protocols and VLAN are installed at the same time.
VLAN configuration procedure
1
Click [Start] – [Administrative Tools] – [Computer Management] to start up
®
Intel PROSet.
2
Click [Network adapters] under [Device Manager] and double-click a LAN.
3
Click the [VLANs] tab, and click [New...].
4
Specify [VLAN ID] and [VLAN Name]. Then click [OK].
The [VLAN ID] should be identical with the switch setting. The configuration range 1 to 4094
can be specified. Any name can be specified as the [VLAN Name].
5
Click [OK] to close the property window for the LAN adapter.
When setup of the VLAN is completed, the following virtual adapter will be created.
• "(LAN Adapter Name)-VLAN:(VLAN Name)"
Upper protocols will be bound with the main virtual adapter. They can not be bound with the
LAN card configuring a VLAN. The IP address should be specified in the main virtual adapter.
PRIMERGY RX600 S4 User's Guide
®
PROSet". Do not disable or delete a VLAN
99