Monitoring Mpls Rsvp Interfaces Information - Juniper J-Series Administration Manual

J-series Services Router Administration Guide
Table 67: Summary of Key RSVP Session Information Output Fields (continued)
Field Values
Transit LSP Information about transit RSVP sessions.
To Destination (outbound router) of the session.
From Source (inbound router) of the session.
State
State of the path:
Rt Number of active routes (prefixes) installed in the
routing table.
Style RSVP reservation style. This field consists of two
parts. The first is the number of active
reservations. The second is the reservation style,
which can be
or
WF
Labelin Incoming label for this RSVP session.
Labelout Outgoing label for this RSVP session.
LSPname Configured name of the LSP.
Total Total number of RSVP sessions displayed for the
particular type—
(outbound), or

Monitoring MPLS RSVP Interfaces Information

To view the interfaces on which RSVP is running, select Monitor>MPLS>RSVP
Interfaces, or enter the following CLI command:
show rsvp interface
Table 68 on page 134 summarizes key output fields in the RSVP interfaces information
display.
Table 68: Summary of Key RSVP Interfaces Information Output Fields
Field Values
RSVP Interface Number of interfaces on which RSVP is active.
Each interface has one line of output.
Interface Name of the interface.
134
Using the Monitoring Tools
Up , Down , or AdminDn
(fixed filter), (shared explicit),
FF SE
(wildcard filter).
ingress (inbound), egress
transit ).
Additional Information
MPLS learns this information by querying RSVP,
which holds all the transit and outbound session
information.
. AdminDn indicates that the LSP is being taken
down gracefully.
For inbound RSVP sessions, the routing table is
the primary IPv4 table (
outbound RSVP sessions, the routing table is the
primary MPLS table (
This field is used for outbound and transit LSPs
only.
Additional Information
). For transit and
inet.0
).
mpls.0